<tr id="awqs4"></tr>
      1. <table id="awqs4"><strike id="awqs4"></strike></table>

        Arduino GSM/GPRS Shield

        Arduino GSM/GPRS Shield
        Arduino GSM/GPRS Shield Arduino GSM/GPRS Shield Arduino GSM/GPRS Shield
        Brand: Tinysine
        Product Code: G50EFC56E3197F
        Reward Points: 0
        Availability: Out Of Stock
        Price: $24.00

        5 or more $22.00
        20 or more $21.00
           - OR -   

         

        SIM900 module are discontinued now. Please change to use our SIM800F GSM shield. It's 100% compatiable with the SIM900 GSM/GPRS Shield.

        The GPRS/GSM Shield provides you a way to use the GSM cell phone network to receive data from a remote location. The shield allows you to achieve this via any of the three methods:

        • Short Message Service
        • Audio
        • GPRS Service

        The GPRS Shield is compatible with all boards which have the same form factor (and pinout) as a standard Arduino Board. The GPRS Shield is configured and controlled via its UART using simple AT commands. Based on the SIM900 module from SIMCOM, the GPRS Shield is like a cell phone. Besides the communications features, the GPRS Shield has 12 GPIOs, 2 PWMs and an ADC.

        Note:

        • Because SIM900 peak current more than 2A. This shield must work with a external DC9V power supply.
        • If you are using MEGA2560. Just need to connect the middle pins of RX and TX jumpers to RX1 TX1 on Arduino Mega 2560. And change the code setting.

        Features

        • Based on SIMCom's SIM900 Module
        • Quad-Band 850 / 900/ 1800 / 1900 MHz - would work on GSM networks in all countries across the world.
        • Control via AT commands - Standard Commands: GSM 07.07 & 07.05 | Enhanced Commands: SIMCOM AT Commands.
        • Short Message Service - so that you can send small amounts of data over the network (ASCII or raw hexadecimal).
        • Embedded TCP/UDP stack - allows you to upload data to a web server.
        • Speaker and Headphone jacks - so that you can send DTMF signals or play recording like an answering machine.
        • SIM Card holder and GSM Antenna - present onboard.
        • 12 GPIOs, 2 PWMs and an ADC (all 2.8 volt logic) - to augment your Arduino.
        • Low power consumption - 1.5mA(sleep mode)
        • Industrial Temperature Range - -40°C to +85 °C

        Document:

        Write a review

        Your Name:


        Your Review: Note: HTML is not translated!

        Rating: Bad            Good

        Enter the code in the box below:



        Tags: GSM, Arduino,
        Powered By Tinyos
        Tinysine (Tinyos) Electronics © 2020
        国产三级